Alhamdulillah, by the grace of God Almighty I can finish writing this tutorial in a way even though no one is perfect except God Almighty but I try to make a tutorial thing two computer network connections or Windows 7 operating pc using LAN cable types Cros 90% perfect.
- LAN cable types (CROS)
- two computers that will connect us
Well after all the first step is to be prepared :
- second turn on your pc
- then enter the LAN cable conductor Cros types into the computer and check if it is installed correctly by looking at the conductor plugs in the computer is powered on the lights or not.
- click start
- Control panel
- Network and Internet
- Network and sharing center
- Change adapter settings
- Select the local area connection See pictures next
- Choose Internet protocol version 4 (TCP/IPv4)
- Type the ip addres type C
192.168.10.2 on pc 2 and click ok
See the image below :
After both PC configured with an IP address that we type in before the next step is to disable the windows firewall on windows operating system windows 7
By the way :
By the way :
- click start
- Control panel
- System and security
- Choose windows firewall
- Turn of it all see the picture beside
After windows firewall is not active the next step is to test the connection by way of :
- click start
- Accessories
- Command prompt (CMD)
Type the following command without the quotes "ping 192.168.10.2" if we are in a position pc 1 pc if in position 2 then type "ping 192.168.10.1" then enter see the image below:
If we get a reply from 192.168.10.2 information destination host unreachable then first check his cable, what is correct or not and check all the steps that you have read the earlier suit yet but what if you get a reply from 192.168.10.2 information bytes = 32 time = 1 ttl = 128 it means you are connected and can be run if the request time out means the connection failed and we need to clarify what the error is happening.
Once the configuration is complete now change the ip address of your computer by name :
- click start
- then right click mycomputer
- select properties
- Select Change and rename your pc as well as select home group
See the image below :
After that we will try shared his data on pc 1 and pc 2 steps as follows :
- Open windows explorer
- Select one of the desired folder for the share
- Right-click the folder
- Select share, and advanced sharing
Tick share this folder is located in the top left corner window when you enter the advanced sharing. If you go to share then select the group home and check the read / write and then click ok, the kedualangkah Perform see the image below :
Once the above step is complete now trying to get in on the Network in windows explorer window see the image below :
If the error persists, examples already found 2 pc computer name on the network window on the share but can not be accessed because they still have to enter a user name and password again, you do not need to worry just follow these steps :
- click start
- Control panel
- Network and Internet
- Select the Home group
- Choose change advanced sharing settings
- Turn right on all but the very bottom of the alone see the image below :
If you have a turn of it password protected sharing, and then you can open a copy and edit the data on the pc and 2 pc 1 see more pictures below :
Well up here first tutorial 2 pc network connection using a LAN cable type Cros on Windows 7 Operating System
Hopefully useful and if there are shortcomings I apologize profusely end I said thank you and bye
NB: Steps - steps that have been in written above it also applies on both pc that will be the object for sharing data on the operating system windows 7 whereas windows xp how to do it was not much different from what I write.
